3D printing supports simplify panoramic shooting
It is not so difficult to make a panoramic picture without use of expensive equipment. Here the cheap mechanized modified support of Manfrotto with introduction special 3D printing details and electronics developed directly for panoramic shooting.
«On one panoramic picture less than a minute leaves, and exact placement of lenses saves a lot of time during post-processing». – designer Ilya Titov writes. The main details are included by Nema 17, Arduino nano cursor, H bridge, sockets, 2 printing drives, 1 printing quick-detachable lens and 1 printing support for the motor.
The fixture of the chamber is developed specially for connection with the slot of a demountable substrate of a support, and distance specially in coordination with a central point of a lens. This design completely understands. It is possible to remove completely everything and your panoramic head again will adopt the primary provision. Details incorporate to the help of cable couplers and hot glue which descends at malekhanky efforts.
«3D printing details very strong, I can lift completely all design, having undertaken the chamber, and it looks reliably. Several times I carried it at myself the whole day, it did not break up». – Titov explained. For Samyang of 8 mm, but it it is possible to adapt design for lenses of the various socket. If you wish to print everything without the aid of others, initial files can be found on Thingiverse. Here, as everything occurs: